User Tools

Site Tools


pmip3:cmip6:design:6k:index

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
Next revision Both sides next revision
pmip3:cmip6:design:6k:index [2015/03/24 09:06]
jypeter created
pmip3:cmip6:design:6k:index [2015/03/24 21:28]
masa
Line 5: Line 5:
 <note tip>\\ Please submit your comments in the Discussion section at the end of this page</​note>​ <note tip>\\ Please submit your comments in the Discussion section at the end of this page</​note>​
  
 +The mid-Holocene (~6000 years ago) is often described as a warm state, or the most recent “climate optimum”, in which dominant features of the global hydrological cycle, such as the North African and Asian monsoon, were amplified. As such, the mid-Holocene has been the focus for paleo-data syntheses since the beginning of the PMIP project and therefore are well documented in terms of temperature,​ hydrological cycle and land surface type. Some long standing model-data disagreement are echoing preoccupations for future climate change, such as the systematic underestimation of the northward penetration of the African monsoon rainfall onto the continent compared to available records for the Mid-Holocene. ​
  
 +The reference experiment to which the mid-Holocene is compared to is the pre-industrial control, which is part of the DECK.
 +
 +For the mid-Holocene,​ our proposed experimental set-up for PMIP-CMIP6 is unchanged compared to the PMIP3-CMIP5 set-up:
 +
 +The main forcing is the ** insolation **, and the astronomical parameters must be set to:
 +
 +**eccentricity** = 0.018682 ​
 +
 +**obliquity** = 24.105° ​
 +
 +**perihelion-180°** = 0.87°
 +
 +**Concentration of atmospheric trace gases:**
 +
 +CO2 = 280 ppm
 +
 +CH4 = 650 ppb
 +
 +N2O = 270 ppb
 +
 +CFC = 0
 +
 +O3 = same as in CMIP5 PI 
 +
 +
 +** Topography/​bathymetry/​coastlines **: unchanged compared to pre-industrial
 +
 +** Vegetation and land surface:**
 +
 +Computed using a dynamical vegetation module,
 +
 +Or prescribed as in PI, with phenology computed for models with active carbon cycle or prescribed from data
 +
 +No change in ice sheet extent
 +
 +
 +** Carbon cycle **
 +
 +Interactive,​ with atmospheric concentration prescribed and ocean and land carbon fluxes diagnosed as recommended in CMIP5
 +
 +** Dust cycle **
 +
 +We invite the modelling groups planning to run simulations with an interactive dust cycle to comment on the most appropriate methodology for their model, in particular as to their ability to use a interactive vegetation description.
  
  
pmip3/cmip6/design/6k/index.txt · Last modified: 2016/06/20 15:34 by jypeter