pmip3:cmip6:design:6k:index
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
pmip3:cmip6:design:6k:index [2015/03/24 22:17] – masa | pmip3:cmip6:design:6k:index [2015/03/27 11:38] – Cosmetic changes jypeter | ||
---|---|---|---|
Line 9: | Line 9: | ||
The reference experiment to which the mid-Holocene is compared to is the pre-industrial control, which is part of the DECK. | The reference experiment to which the mid-Holocene is compared to is the pre-industrial control, which is part of the DECK. | ||
- | For the mid-Holocene, | + | For the **mid-Holocene**, our proposed experimental set-up for PMIP-CMIP6 is unchanged compared to the [[pmip3: |
+ | |||
+ | ===== Orbital parameters ===== | ||
+ | |||
+ | The main forcing is the ** insolation **, and the astronomical parameters must be set to: | ||
- | The main forcing is the insolation, and the astronomical parameters must be set to: | ||
**eccentricity** = 0.018682 | **eccentricity** = 0.018682 | ||
+ | |||
**obliquity** = 24.105° | **obliquity** = 24.105° | ||
+ | |||
**perihelion-180°** = 0.87° | **perihelion-180°** = 0.87° | ||
- | **Concentration of atmospheric trace gases:** | + | **solar constant** = same as in pre-industrial |
- | CO2 = 280 ppm | + | |
- | CH4 = 650 ppb | + | ===== Concentration of atmospheric trace gases ===== |
- | N2O = 270 ppb | + | |
- | CFC = 0 | + | **CO< |
- | O3 = same as in CMIP5 PI | + | |
+ | **CH< | ||
+ | |||
+ | **N< | ||
+ | |||
+ | **CFC** = 0 | ||
+ | |||
+ | **O< | ||
+ | |||
+ | |||
+ | ===== Topography/ | ||
+ | |||
+ | Unchanged compared to pre-industrial | ||
+ | |||
+ | ===== Vegetation and land surface ===== | ||
+ | |||
+ | * Computed using a dynamical vegetation module, | ||
+ | * or prescribed as in PI, with phenology computed for models with active carbon cycle | ||
+ | * or prescribed from data | ||
+ | |||
+ | No change in ice sheet extent | ||
+ | ===== Carbon cycle ===== | ||
+ | Interactive, | ||
+ | ===== Dust cycle ===== | ||
+ | We invite the modelling groups planning to run simulations with an interactive dust cycle to comment on the most appropriate methodology for their model, in particular as to their ability to use an interactive vegetation description. | ||
pmip3/cmip6/design/6k/index.txt · Last modified: 2025/05/15 17:41 by jypeter