User Tools

Site Tools


pmip3:design:6k:index

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
pmip3:design:6k:index [2009/02/06 20:08]
pasb
pmip3:design:6k:index [2010/02/12 14:54]
jypeter Added link to 8k2
Line 1: Line 1:
 ~~ODT~~ ~~ODT~~
-~~DISCUSSION~~+~~DISCUSSION:closed~~
  
-//Go to =>// [ [[pmip3:​design:​pi:​index|PI]] ] - [ [[pmip3:​design:​21k:​index|21ka]] ] - [ [[pmip3:​design:​lm:​index|LM]] ] +<​html><​a name="​page_top_tag">&​nbsp</​a></​html>​ 
-====== 6ka Experimental Design ======+//Go to =>// [ [[pmip3:​design:​pi:​index|PI]] ​] - [ **6ka** ​] - [ [[pmip3:​design:​21k:​index|21ka]] ] - [ [[pmip3:​design:​lm:​index|LM]] ] - [ [[pmip3:​design:​8k2:​index|8.2ka]] ] - [ [[pmip3:​design:​li:​index|LI]] ] - [ [[pmip3:​design:​plio:​index|Plio]] ]
  
  
 +====== 6ka Experimental Design ======
 +
 +<note warning>​**Page in progress**: this is not the final version!\\ \\ Use the [[index#​page_bottom_tag|discussion]] panel at the end of the page for comments </​note>​
  
 ===== Boundary conditions ===== ===== Boundary conditions =====
  
-**Summary of 6ka boundary conditions ​**+==== Summary of 6ka boundary conditions ​====
  
-^      ^   ​PMIP3 ​ ^  ​Alternative ​solution ^ + 
-|  Orbital parameters ​ |  **ecc**=0.018682,   **obl**=24.105 °,   **peri-180°**= 0.87 °  | | +^      ^   PMIP3/​CMIP5 ​ ​^  ​Minimum ​solution ​ 
-|  ​date of the Vernal ​equinox ​ |  March 21 at Noon  | | +|  Orbital parameters ​ |  ​**ecc** = 0.018682 ​] - [ **obl** = 24.105° ] - [ **peri-180°** = 0.87° ]  ​| ​ 
-|  Trace Gazes  ​| ​ **CO<​sub>​2</​sub>​** = 280 ppm**CH<​sub>​4</​sub>​** = 650 ppb**N<​sub>​2</​sub>​O** = 270 ppb**CFC** = 0**O<​sub>​3</​sub>​** = same as PI  | |+|  ​Date of vernal ​equinox ​ |  March 21 at noon  | | 
 +|  Trace gases  ​|  ​**CO<​sub>​2</​sub>​** = 280 ppm ] - [ **CH<​sub>​4</​sub>​** = 650 ppb ] - [ **N<​sub>​2</​sub>​O** = 270 ppb ] - [ **CFC** = 0 ] - [ **O<​sub>​3</​sub>​** = same as PI  | |
 |  Aerosols ​ |  Same as PI  | | |  Aerosols ​ |  Same as PI  | |
 |    | |  | |    | |  |
-|  Solar constant ​ |  ​1365W/​m<​sup>​2</​sup> ​ |  As in PI  | +|  Solar constant ​ |  ​1365 W/​m<​sup>​2</​sup> ​ |  As in PI  | 
-|  Vegetation ​    ​|  ​Interactive ​ ​| ​ See specific note below +|  Vegetation ​    ​|  ​prescribed or interactive as in CMIP5 PI  ​| ​   
-|  Ice sheet      ​|  ​remnant ​Laurentide ice-sheet (provided) ​ |  Same as PI  | +|  Ice sheets ​     ​|  ​Remnant ​Laurentide ice-sheet (provided*)  |  Same as PI  | 
-|  Topography and coastline ​ ​| ​ Modification of the Hudson Bay (provided) ​ |  Same as PI  |+|  Topography and coastlines ​ ​| ​ Modification of Hudson Bay coastlines ​(provided*)  |  Same as PI  |
  
 +*For the ice-sheet reconstruction,​ see discussion on LGM wiki page
  
-** Vegetation  ​** +Please use the [[index#​page_bottom_tag|discussion]] panel to **comment** this table!
-Depending on the complexity of the model used the vegetation will be either \\ +
-- computed by the model \\ +
-- prescribed to PI \\ +
-- prescribed to 6ka vegetation reconstructed from a combination of model output and data analyses (please use the map provided here) \\ +
-- Obtained from asynschonous coupling with a DVGM (Biome 4 model provided ) +
  
  
-** For Earth System Model with interactive carbone cycle ** +==== Vegetation ====
-The simlations are force by the CO2 concentrations. Please use the same protocal as in CMIP5 to store the carbone fluxes and the variables needed for PCMIP (see list here) +
  
-** Insolation ** +The vegetation ​should ​be treated as in the CMIP5 PI experimentThe reason is that in CMIP5 we test the version of the model used for future climate projections. Since OA and ESM models will be considered, depending on the model used the vegetation will be 
-Note that insolation ​should ​follows PMIP requirementsPlease check it carefuly using the following tables ​+
  
 +  * prescribed to PI (which means both vegetation types and LAI are prescribed )
 +  * Prescribed to PI with interactive LAI (models with interactive carbone cycle, but no vegetation dynamics)
 +  * Computed by the model (models with dynamic vegetation) ​
  
 +There are still questions concerning the possibility to have a 6ka reconstructed vegetation from a combination of model output and data analyses that could be used for sensitivity experiments. Please tell if you are interested by such a map and what would be the best variables (pft?) that should be provided (see comment from B. Otto-Bliesner in the discussion pannel).  ​
  
-===== Initial conditions =====+==== For Earth System Models with interactive carbone cycle ====
  
-^  ^ PMIP3 ^ Alternative solution ^ +The simulations are forced by CO2 concentrations. Please use the same protocol as in CMIP5 to store the carbone fluxes and the variables needed for PCMIP (see list here)  
-| Initial conditions ​|  branch off PI after adjustement | Same as in PI | + 
-| Model spin up      |  Same as in PI |  |+==== Insolation ==== 
 + 
 +Note that insolation should follows PMIP requirements. Please check it carefully using the following tables ([[http://​pmip2.lsce.ipsl.fr/​design/​tables/​inso_tables_6k.shtml|6ka BP insolation tables]]) 
 + 
 + 
 + 
 + 
 + 
 +===== Initial conditions ​=====
  
 +^  ^  PMIP3  ^  Alternative solution ​ ^
 +| Initial conditions |  Branch off PI after adjustement ​ |  Same as in PI  |
 +| Model spin up      |  Same as in PI  |  |
  
  
Line 51: Line 64:
 [ [[pmip3:​|PMIP3 Wiki Home]] ] - [ [[pmip3:​|PMIP3 Wiki Home]] ] -
 [ [[pmip3:​wiki_help|Help!]] ] - [ [[pmip3:​wiki_help|Help!]] ] -
-[ [[wiki:​syntax|Wiki syntax]] ]+[ [[wiki:​syntax|Wiki syntax]] ] <​html><​a name="​page_bottom_tag">&​nbsp</​a></​html>​ - [ [[index#​page_top_tag|Top]] ]
pmip3/design/6k/index.txt · Last modified: 2010/09/16 12:35 by jypeter