Differences

This shows you the differences between two versions of the page.

--- pmip3:design:8k2:index [2010/03/30 11:39] – renssen
+++ pmip3:design:8k2:index [2012/03/07 22:59] (current) – morrill
@@ Line 9: / Line 9: @@
 <note warning>**Page in progress**: this is not the final version!\\ \\ Use the [[index#page_bottom_tag|discussion]] panel at the end of the page for comments </note>
+<note important>Information about metadata and variables to be contributed can be found here:
+{{:pmip3:docs:8k-variables.xlsx|}}</note>
 ===== Boundary conditions =====
+<note>The following are ideal boundary conditions, but experiments that deviate from these boundary conditions may also be contributed if complete metadata are provided. </note>
 ==== Summary of 8.2ka boundary conditions ====
@@ Line 20: / Line 27: @@
 |  Aerosols  |  Same as PI  | |
 |    | |  |
-|  Solar constant  |  1365 W/m<sup>2</sup>  |  As in PI  |
+|  Solar constant  |  As in PI  |    |
 |  Vegetation     |  prescribed or interactive as in CMIP5 PI  |    |
 |  Ice sheets      |  Remnant Laurentide ice-sheet (provided*)  |  Same as PI  |
@@ Line 38: / Line 45: @@
 **Proposed Lake Agassiz drainage** (mandatory):
-| Fux       | 2.5 Sv over 1 year   |
+| Flux       | 2.5 Sv over 1 year   |
 | Location  | Either part or all of the Labrador Sea (up to the individual modeling groups, as long as it is not added outside the Labrador Sea)|
 | Ensemble  | this experiment should be completed at least three times, beginning at different years in the control simulation|
 | Duration  | experiment should be integrated until the AMOC recovers, except in the case of unrealistically long (i.e., multicentury) recoveries|
 ==== Vegetation ====
@@ Line 51: / Line 59: @@
-==== For Earth System Models with interactive carbone cycle ====
+==== For Earth System Models with interactive carbon cycle ====
-The simulations are forced by CO2 concentrations. Please use the same protocol as in CMIP5 to store the carbone fluxes and the variables needed for PCMIP (see list here)
+The simulations are forced by CO2 concentrations. Please use the same protocol as in CMIP5 to store the carbon fluxes and the variables needed for PCMIP (see list here)
 ==== Insolation ====