pmip3:design:li:index
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
pmip3:design:li:index [2010/07/29 13:58] – lunt | pmip3:design:li:index [2010/09/16 14:33] (current) – Added link to final BC page in the top warning jypeter | ||
---|---|---|---|
Line 1: | Line 1: | ||
~~ODT~~ | ~~ODT~~ | ||
- | ~~DISCUSSION~~ | + | ~~DISCUSSION:closed~~ |
< | < | ||
Line 9: | Line 9: | ||
====== Last Interglacial Experimental Design ====== | ====== Last Interglacial Experimental Design ====== | ||
- | <note warning>**Page in progress**: this is not the final version!\\ \\ Use the [[index# | + | <note warning>This was a BC // |
===== Goal ===== | ===== Goal ===== | ||
- | Run **early Eemian**, **mid-Eemian** and **glacial inception** snap shots. This will allow us to model the response to obliquity maximum (//130ka//) and minimum (// | + | Run **early Eemian**, **mid-Eemian** and **glacial inception** snap shots. This will allow us to model the high latitude |
==== Core experiments ==== | ==== Core experiments ==== | ||
Line 96: | Line 96: | ||
^ ^ | ^ ^ | ||
- | | Orbital parameters | + | | Orbital parameters |
| Date of vernal equinox | | Date of vernal equinox | ||
- | | Trace gases | varying, model interpolates values given on a 0.1k resolution. | + | | Trace gases | varying, model interpolates values given on a 0.1k resolution. |
| Aerosols | | Aerosols | ||
| | | | | | | | | | ||
Line 111: | Line 111: | ||
^ ^ | ^ ^ | ||
- | | Orbital parameters | + | | Orbital parameters |
| Date of vernal equinox | | Date of vernal equinox | ||
- | | Trace gases | varying, model interpolates values given on a 0.1k resolution. | + | | Trace gases | varying, model interpolates values given on a 0.1k resolution. |
| Aerosols | | Aerosols | ||
| | | | | | | | | | ||
Line 142: | Line 142: | ||
For transients: | For transients: | ||
- | ^ ^ PMIP3 ^ Alternative solution | + | ^ ^ PMIP3 ^ Alternative solution |
- | | Initial conditions | Branch off PI after adjustment | + | | Initial conditions | Branch off PI after adjustment |
- | | Model spin up | 2kyr or less before transient starts | Same as in PI | | | + | | Model spin up | 2kyr or less before transient starts | Same as in PI | |
For initial conditions, and especially spinup, the key thing is to document what you do! | For initial conditions, and especially spinup, the key thing is to document what you do! | ||
+ | |||
+ | For the transient simulations, | ||
===== Participating groups ===== | ===== Participating groups ===== |
pmip3/design/li/index.1280404732.txt.gz · Last modified: 2010/07/29 13:58 by lunt