Differences

This shows you the differences between two versions of the page.

--- pmip3:design:pi:index [2009/02/12 13:19] – Try to add a link to the bottom of the page jypeter
+++ pmip3:design:pi:index [2010/09/16 14:35] (current) – Added link to final BC page in the top warning jypeter
@@ Line 1: / Line 1: @@
 ~~ODT~~
-~~DISCUSSION~~
+~~DISCUSSION:closed~~
-//Go to =>// [ [[pmip3:design:6k:index|6ka]] ] - [ [[pmip3:design:21k:index|21ka]] ] - [ [[pmip3:design:lm:index|LM]] ]
+<html><a name="page_top_tag">&nbsp</a></html>
+//Go to =>// [ **PI** ] - [ [[pmip3:design:6k:index|6ka]] ] - [ [[pmip3:design:21k:index|21ka]] ] - [ [[pmip3:design:lm:index|LM]] ] - [ [[pmip3:design:8k2:index|8.2ka]] ] - [ [[pmip3:design:li:index|LI]] ] - [ [[pmip3:design:plio:index|Plio]] ]
 ====== Pre-Industrial Control Run Experimental Design ======
-<note warning>**Page in progress**: this is not the final version!\\ \\ Use the [[index#page_bottom_tag|discussion]] panel add the end of the page for comments </note>
+<note warning>This was a BC //development page// (see [[index#page_bottom_tag|discussion]] panel at the end of the page)\\ \\ Make sure you use the [[pmip3:design:pi:final|final version of the PI BC]]!</note>
@@ Line 14: / Line 15: @@
 ==== PI for PMIP3/CMIP5 experiments====
-The Preindustrial control should be the same as the one used for CMIP5 experiments. It is thus the same reference as the one for 20th century simulations and future climate projections (see {{:pmip3:docs:taylor_cmip5_dec31.pdf}}).
+The Preindustrial control should be the same as the one used for CMIP5 experiments. It is thus the same reference as the one for 20<sup>th</sup> century simulations and future climate projections (see {{:pmip3:docs:taylor_cmip5_dec31.pdf}}).
 ==== PI for groups only running PMIP3 experiments ====
+=== Summary of PI boundary conditions ===
 ^      ^   PMIP3  ^  Alternative solution ^
-|  Orbital parameters  |  **ecc** = 0.016724\\   **obl** = 23.446°\\   **peri-180°** = 102.04°  | |
+|  Orbital parameters  |  [ **ecc** = 0.016724 ] - [ **obl** = 23.446° ] - [ **peri-180°** = 102.04° ]  | |
 |  Date of vernal equinox  |  March 21 at noon  | |
-|  Trace gases  |  **CO<sub>2</sub>** = 280 ppm\\ **CH<sub>4</sub>** = 760 ppb\\ **N<sub>2</sub>O** = 270 ppb\\ **CFC** = 0\\ **O<sub>3</sub>** = Modern - 10 DU  | |
+|  Trace gases  |  [ **CO<sub>2</sub>** = 280 ppm ] - [ **CH<sub>4</sub>** = 760 ppb ] - [ **N<sub>2</sub>O** = 270 ppb ] - [ **CFC** = 0 ] - [ **O<sub>3</sub>** = Modern - 10 DU ]  | |
 |  Aerosols  |  Same as PI  | |
 |    | |  |
-|  Solar constant  |  1365W/m<sup>2</sup>  |  As in PI  |
+|  Solar constant  |  1365 W/m<sup>2</sup>  |  As in PI  |
-|  Vegetation     |  Interactive  |  See specific note below |
+|  Vegetation     |  Interactive  |  See specific note below  |
 |  Ice sheets      |  Present day  |    |
 |  Topography and coastline  |  Present day  |    |
+Please use the [[index#page_bottom_tag|discussion]] panel to **comment** this table!
 === Vegetation ===
-Depending on the complexity of the model used the vegetation will be either \\
+Depending on the complexity of the model used the vegetation will be either:
-- computed by the model \\
-- prescribed to PI (some ESMs may also only compute vegetation phenology and carbon cycle).\\
+  * computed by the model
+  * prescribed to PI (some ESMs may also only compute vegetation phenology and carbon cycle).
 === Land use ===
@@ Line 42: / Line 47: @@
 Land use should be included in the PI vegetation map. In that case, care should be taken that the land use map used in the PI simulation is consistent with the one used for land use evolution either for the 20th century or the last Millennium.
-=== For Earth System Models with interactive carbone cycle ===
+=== For Earth System Models with interactive carbon cycle ===
-The simulations are forced by the CO2 concentrations. Please use the same protocol as in CMIP5 to store the carbone fluxes and the variables needed for PCMIP (see list here [[http://example.com|External Link]])
+The simulations are forced by the CO2 concentrations. Please use the same protocol as in CMIP5 to store the carbon fluxes and the variables needed for PCMIP (see list here [[http://example.com|External Link]])
 === Insolation ===
-Note that insolation should follows PMIP requirements. Please check it carefully using the following tables ([[http://pmip2.lsce.ipsl.fr/design/tables/inso_tables_0k.shtml|PI insolation tables]])
+Note that insolation should follow PMIP requirements. Please check it carefully using the following tables ([[http://pmip2.lsce.ipsl.fr/design/tables/inso_tables_0k.shtml|PI insolation tables]])
@@ Line 61: / Line 66: @@
 [ [[pmip3:|PMIP3 Wiki Home]] ] -
 [ [[pmip3:wiki_help|Help!]] ] -
-[ [[wiki:syntax|Wiki syntax]] ] <html><a name="page_bottom_tag">&nbsp</a></html>
+[ [[wiki:syntax|Wiki syntax]] ] <html><a name="page_bottom_tag">&nbsp</a></html> - [ [[index#page_top_tag|Top]] ]