Differences

This shows you the differences between two versions of the page.

--- test_cases:six [2014/05/20 14:05]
grenier
+++ test_cases:six [2020/06/30 16:16] (current)
grenier
@@ Line 1: / Line 1: @@
-**Case TH2: Closure / Opening of a talik due to challenging inflowing water and negative temperatures imposed on lateral sides**
+**Case TH3: Closure / Opening of a talik due to challenging inflowing water and negative temperatures imposed on lateral sides**
-The full coupled system is involved. The difference with Case TH1 is that an imposed cold boundary condition is imposed that challenges the effect of water heat advection. Depending on the intensity of the flow, the initial talik system opens or closes.
+The full coupled system is resolved.
-Initial conditions are provided below (boolean temperature zones, +5°C in the middle, the talik, and -5°C in the semi-circular geometries to the side). Heat boundary conditions are imposed upstream (left) temperature (+5°C), downstream conductive component no-flow (exit by advection only), imposed negative temperatures (-5°C) on lateral sides. Water boundary conditions are the same as for TH1, basically uniform flow conditions.
+The difference with Case TH1 is that a cold boundary condition is imposed that challenges the effect of water heat advection. Depending on the intensity of the flow, the initial talik system opens or closes.
-{{:test_cases:cas2.jpg?300|}}     {{:test_cases:conditions_hydro.jpg?300|}}
+Initial conditions are provided below (boolean temperature zones, +5°C in the middle, the talik, and -5°C in the semi-circular geometries to the side). Heat boundary conditions are imposed upstream (left) temperature (+5°C), downstream conductive component no-flow (exit by advection only), imposed negative temperatures (-5°C) on lateral sides.
+{{ cas2.jpg?300 }}
+Water boundary conditions are the same as for TH1, basically uniform flow conditions.
+{{ conditions_hydro.jpg?300 }}
+**The whole information about Benchmark Case TH3 (including parameter spread sheet, performance measures) is available as   {{:test_cases:th3_parameters_v2-1.pdf|pdf file}} (Version 2.1, 18/02/2015). Please consider as well some more recent additional information and modifications provided in {{:test_cases:th2_3_parameter_sheet_complement.pdf|}} (11 May 2015).**
+**The results are now published and available as data file from the [[intercomparaison_results:test_case1|results]] page**