This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
other:uvcdat:cdat_conda:cdat_8_0_py2 [2019/03/05 17:04] jypeter Added the CLIMAF section |
other:uvcdat:cdat_conda:cdat_8_0_py2 [2019/03/07 10:04] jypeter [Installing CLIMAF] |
||
---|---|---|---|
Line 436: | Line 436: | ||
* <code>cd climaf/testing | * <code>cd climaf/testing | ||
./test_install.sh</code> | ./test_install.sh</code> | ||
- | * Once the tests are OK, add the required //module load// and environment variables definitions to the ''.basrc'' and ''.cshrc'' files. <wrap hi>Note: maybe these lines should go to the ''.profile'' and ''.login'' files...</wrap> | + | * Once the tests are OK, add the required //module load// and environment variables definitions to the ''.basrc'' and ''.cshrc'' files. <wrap hi>Note: maybe these lines should go to the ''.profile'' and ''.login'' files...(check [[https://www.gnu.org/software/bash/manual/html_node/Bash-Startup-Files.html|Bash Startup Files]])</wrap> |
* LSCE: add to your .cshrc | * LSCE: add to your .cshrc | ||
* <code># Prerequisites for using CLIMAF | * <code># Prerequisites for using CLIMAF | ||
Line 468: | Line 468: | ||
</code> | </code> | ||
* Open a new shell and <wrap em>run the tests again</wrap>. If there is an error that was not there, check what you have added to the shell init files | * Open a new shell and <wrap em>run the tests again</wrap>. If there is an error that was not there, check what you have added to the shell init files | ||
+ | * [[other:uvcdat:cdat_conda:climaf_test|Test CLIMAF on ciclad]] | ||
==== Cleaning up things ==== | ==== Cleaning up things ==== |