other:x_conf
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
other:x_conf [2022/08/09 12:46] jypeter [Installing x410] |
other:x_conf [2022/08/09 13:26] jypeter [If you are connecting with ssh or PuTTY] |
||
|---|---|---|---|
| Line 96: | Line 96: | ||
| ===== Using an X server on a Mac ===== | ===== Using an X server on a Mac ===== | ||
| + | ==== Installing XQuartz ==== | ||
| + | |||
| + | Type: <wrap em>free</wrap> | ||
| + | |||
| + | Download the installer from [[https://www.xquartz.org|XQuartz]] and install it | ||
| + | |||
| + | === XQuartz configuration === | ||
| + | |||
| + | <WRAP center round tip 60%> | ||
| + | Nothing to configure! | ||
| + | </WRAP> | ||
| ===== Configuration on the remote Linux server ===== | ===== Configuration on the remote Linux server ===== | ||
| Line 101: | Line 112: | ||
| ==== If you are connecting with ssh or PuTTY ==== | ==== If you are connecting with ssh or PuTTY ==== | ||
| - | Nothing special to do, if you are using [[other:ssh#using_an_x_server_to_display_graphics|"ssh -X" or "ssh -Y"]] or ''PuTTY'' to connect to a remote Linux server | + | Nothing special to do, if you are using [[other:ssh#using_an_x_server_to_display_graphics|"ssh -X" or "ssh -Y"]] or a [[other:putty_conf#changing_some_useful_settings|correctly configured PuTTY]] to connect to a remote Linux server |
| ==== If you are using WSL ==== | ==== If you are using WSL ==== | ||
other/x_conf.txt · Last modified: 2023/06/30 08:20 by jypeter
