other:x_conf
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
other:x_conf [2022/08/09 15:46] jypeter [What is an X server?] Note about DISPLAY, and foreword |
other:x_conf [2022/08/10 07:26] jypeter Reordered the Troubleshooting subsections |
||
|---|---|---|---|
| Line 228: | Line 228: | ||
| [Remote] $ xterm &</code> | [Remote] $ xterm &</code> | ||
| + | |||
| ==== On a Mac ==== | ==== On a Mac ==== | ||
| FIXME | FIXME | ||
| + | |||
| + | |||
| ===== Troubleshooting ===== | ===== Troubleshooting ===== | ||
| + | |||
| ==== Nothing works! ==== | ==== Nothing works! ==== | ||
| Line 244: | Line 248: | ||
| * Is the [[other:x_conf#what_is_an_x_server|DISPLAY variable]] defined correctly on the local and remote computer? | * Is the [[other:x_conf#what_is_an_x_server|DISPLAY variable]] defined correctly on the local and remote computer? | ||
| - | === When DISPLAY is not defined correctly === | + | |
| + | ==== Error when there is no X server running ==== | ||
| + | |||
| + | If the ''DISPLAY'' variable is defined, but there is **no X server**, you will get a ''Can't open display: localhost://[SOME VALUE]//'' error\\ <code>$ xterm & | ||
| + | xterm: Xt error: Can't open display: localhost:23.0</code> | ||
| + | |||
| + | Time to [[other:x_conf|read this page again]]... | ||
| + | |||
| + | |||
| + | ==== Error when DISPLAY is not defined correctly ==== | ||
| If the ''DISPLAY'' **variable is not defined (correctly)**, you will get a ''Can't open display: //[NO VALUE DISPLAYED HERE]//'' error | If the ''DISPLAY'' **variable is not defined (correctly)**, you will get a ''Can't open display: //[NO VALUE DISPLAYED HERE]//'' error | ||
| Line 260: | Line 273: | ||
| Make sure that you are using ''ssh -X'' or ''ssh -Y'', or that [[other:putty_conf#changing_some_useful_settings|PuTTY is configured]] with ''Enable X11 forwarding'' | Make sure that you are using ''ssh -X'' or ''ssh -Y'', or that [[other:putty_conf#changing_some_useful_settings|PuTTY is configured]] with ''Enable X11 forwarding'' | ||
| - | === When there is no X server running === | ||
| - | If the ''DISPLAY'' variable is defined, but there is **no X server**, you will get a ''Can't open display: localhost://[SOME VALUE]//'' error\\ <code>$ xterm & | + | ==== Can't start a graphical application by clicking on its desktop shortcut ==== |
| - | xterm: Xt error: Can't open display: localhost:23.0</code> | + | |
| + | Check the shortcut and run the command directly in a terminal to check the error message | ||
| + | |||
| + | There is a good chance that [[other:x_conf#error_when_there_is_no_x_server_running|you have forgotten to start the X server!]] | ||
| - | Time to [[other:x_conf|read this page again]]... | ||
| ==== OpenGL related settings ==== | ==== OpenGL related settings ==== | ||
other/x_conf.txt · Last modified: 2023/06/30 08:20 by jypeter
