User Tools

Site Tools


pmip3:design:pi:final:icesheet

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
pmip3:design:pi:final:icesheet [2009/12/04 13:19]
pasb
pmip3:design:pi:final:icesheet [2013/10/16 10:45] (current)
jypeter [Northern Hemisphere (GLAC-1)] Added ref to EPSL 2012 paper
Line 4: Line 4:
  
 ===== Introduction ===== ===== Introduction =====
 +
 +
 +
 +//Note: use paragraph below...
 +
 +The ice sheet provided for PMIP3/CMIP5 LGM experiments is a blended product obtained by averaging three different ice sheets:
 +  * ICE6G provided by Dick Peltier
 +  * MOCA provided by Lev Tarasov
 +  * ANU provided by Kurt Lambeck
 +
 +A short description and references for the different ice sheets is provided under the link below: ​
 +[[pmip3:​design:​pi:​final:​icesheet|LGM icesheet description]]
 +
 +This solution was proposed by PMIP bureau in light of a community checking. Given the uncertainties that still exist on the reconstruction of the ice-sheet, resulting from uncertainties in datation for the data used for global or regional constraints,​ climate intput from ice core temperature reconstructions or climate model simulations,​ etc... it sounds reasonable to consider that the average is a best estimate of the LGM ice-sheet.//​
  
 Several PMIP participants were in favour of using a new ice-sheet reconstruction for PMIP3/CMIP5 that better matches the geomorphologic and glaciological constraints than the ICE-5G reconstruction used in PMIP2. ​ Several PMIP participants were in favour of using a new ice-sheet reconstruction for PMIP3/CMIP5 that better matches the geomorphologic and glaciological constraints than the ICE-5G reconstruction used in PMIP2. ​
Line 15: Line 29:
  
 ===== Ice-sheet reconstruction to be used for PMIP3/CMIP5 simulations ===== ===== Ice-sheet reconstruction to be used for PMIP3/CMIP5 simulations =====
- + Procedure to make the averages. 
 + 
 +0. Sources: 
 +   - <H, RSL> ​ ANU ice model (2009) incl. British area (*1) 
 +   - <s, mask> ICE-6G v1.02 
 +   - <H, s>    GLAC-1 nn454 model for North America, and ne8234 for Eurasia 
 + 
 +   ​H: ​   thickness 
 +   ​s: ​   surface topography 
 +   mask: ice or not 
 + 
 + *1 Only the ice thickness at 20ka is provided for the British region 
 +    at the moment. ​ RSL is computed with assumption of mantle density 
 +    4500 kg m-3. 
 +    Surface elevation at LGM is computed as follows: 
 +      s[LGM,ANU] = s[present,​ICE-6G] + H[LGM,ANU] - RSL[LGM,​ANU] 
 + 
 +1. Interpolation on to ICE-6G domain 
 + 
 +  /ICE-6G domain/ 
 +    lon [0, 1, ..., 359] 
 +    lat [-89.5, -88.5, ..., 89.5] 
 + 
 +  Gridpoints out of the sources are set `Undefined'​ 
 + 
 +  *Resolution Notes* 
 +    ANU    Antarctica ​        ​[-179,​180] ​     x [-89.5,​-61.5] ​  1 deg 
 +           ​Eurasia ​           [0,​115.5] ​      x [50.25,​83] ​     0.5 deg 
 +           North AMerica ​     [-139,​-7] ​      x [38,​84.5] ​      0.5 deg 
 +           ​British ​           [-10,​-2] ​       x [52,​59] ​        1 deg 
 +    GLAC-1 North America ​     [187.5,​354.5] ​  x [34.75,​84.25] ​  1 x 0.5 deg 
 +           ​Eurasia ​           [347.25,​479.25] x [48.125,​83.125] 0.5 x 0.25 deg 
 + 
 +2. Average 
 + 
 +  The average is computed as follows: 
 +    X(ave) = [X(ANU) + X (6G) + X(GLAC-1)] / <Number of `defined'​ grids> 
 + 
 +  X(ANU or GLAC-1) = X (if defined) 
 +                or = 0 (if undefined) 
 + 
 +3. Plots 
 + 
 +{{:​pmip3:​design:​pi:​final:​antarctica21ka.pdf|}} 
 + 
 + 
 +  In the surface topography plots, light green indicates that the 
 +  elevation at the gridpoint is below zero;  brown is above zero but 
 +  not covered by ice; grey or blank region are `undefined'​ gridpoints. 
 + 
 +  Number of `defined` grids are plotted besides the average in the 
 +  NH figure. ​ Red = 1, Blue = 2, Magenta = 3. 
 +  By this configuration;​ Magenta corresponds to the ANU domain, 
 +  magenta and blue to GLAC-1 domain, and all region to the ICE-6G 
 +  domain, respectively. 
 +  There is a region of isolated red at the north of Alaska. ​ This is 
 +  because of the `undefined'​ grids in the GLAC-1 source. ​ I have no 
 +  idea why this isolated region is undefined in the GLAC-1. 
 + 
 +  Average surface topography shows straight coastline at the Bering 
 +  strait on the Alaska part.  This reflects the original GLAC-1 data. 
 +  I think this region should be skipped when averaging, but this is 
 +  just a quick-look. 
 + 
 +  Number of `defined` grids are NOT plotted in the SH figure. 
 +  But, this is easily deduced by other two plots. ​
   ​   ​
  
Line 81: Line 160:
 108(B3), 2143, doi:​10.1029/​2001JB001731,​ 2003]] 108(B3), 2143, doi:​10.1029/​2001JB001731,​ 2003]]
   * [[http://​www.atmosp.physics.utoronto.ca/​people/​lev/​g5jpub.pdf|Tarasov,​ L., and W. R. Peltier, Greenland glacial history and local geodynamic consequences,​ Geophysical Journal International,​ Volume 150, Pages 198-229, doi:​10.1046/​j.1365-246X.2002.01702.x,​ 2002]]   * [[http://​www.atmosp.physics.utoronto.ca/​people/​lev/​g5jpub.pdf|Tarasov,​ L., and W. R. Peltier, Greenland glacial history and local geodynamic consequences,​ Geophysical Journal International,​ Volume 150, Pages 198-229, doi:​10.1046/​j.1365-246X.2002.01702.x,​ 2002]]
 +  * [[http://​www.sciencedirect.com/​science/​article/​pii/​S0012821X11005243|Tarasov,​ Lev and Arthur S. Dyke and Radford M. Neal and W. R. Peltier, A data-calibrated distribution of deglacial chronologies for the North American ice complex from glaciological modeling, Earth and Planetary Science Letters, Volumes 315–316, 15 January 2012, Pages 30-40]]
  
 === Data === === Data ===
pmip3/design/pi/final/icesheet.1259932769.txt.gz · Last modified: 2009/12/04 13:19 by pasb