User Tools

Site Tools


pmip3:design:pi:index

This is an old revision of the document!


Export page to Open Document format

Go to ⇒ [ 6ka ] - [ 21ka ] - [ LM ]

Pre-Industrial Control Run Experimental Design

Page in progress: this is not the final version

Use the discussion pannel below for comments

Boundary conditions

PI for PMIP3/CMIP5 experiments

The Preindustrial control should be the same as the one used for CMIP5 experiments. It is thus the same reference as the one for 20th century simulations and future climate projections (External Link).

PI for groups only running PMIP3 experiments

PMIP3 Alternative solution
Orbital parameters ecc=, obl= °, peri-180°= °
date of the Vernal equinox March 21 at Noon
Trace Gazes CO2 = ppm, CH4 = ppb, N2O = ppb, CFC = 0, O3 = same as PI
Aerosols Same as PI
Solar constant 1365W/m2 As in PI
Vegetation Interactive See specific note below
Ice sheet Present day
Topography and coastline Present day

Vegetation Depending on the complexity of the model used the vegetation will be either
- computed by the model
- prescribed to PI (some ESM may only compute vegetation phenology and carbon cycle).

Land use Land use should be included in the PI vegetation map. In that case, take care that the land use map you use in the PI simulations is consistent with what is done for land use evolution either on the 20th century or the last Millenium.

For Earth System Model with interactive carbone cycle The simlations are force by the CO2 concentrations. Please use the same protocal as in CMIP5 to store the carbone fluxes and the variables needed for PCMIP (see list here External Link)

Insolation Note that insolation should follows PMIP requirements. Please check it carefuly using the following tables (External Link)

Initial conditions

Discussion

Gavin Schmidt, 2009/02/10 21:02

Since PMIP won't be able to regulate the insolation that people use in the 20C3M runs and the standard controls, and some people will be varying insolation in the LM runs, more guidance is required here. Maybe, we should specify 1850AD conditions?

Pascale Braconnot, 2009/02/12 17:11

Then what is the value you recommend in that case / the 1365W/m2 required in PMIP, which is already different from the 1367 a lot of group have in practive in their code? For the orbital parameters I can look at it. But I am not sure we will be able to do something. The real pb is what will be the PI for the Millenium simulations ? It should be year 850, but then how do we connect this with the preindustrial (1860 usually run for CMIP?). Also PMIP gaz etc… was rather 1750 than 1860. I see similar pb with the landuse map.

PMIP3 Guest Login, ottobli@ucar.edu, 2009/02/21 18:57

For the PI for groups only running PMIP3 experiments, we should define both an orbital year and the associated orbital parameters. It would be useful to query the CMIP5 modeling groups to determine what orbital definition will be used in their controls and 20C3M runs. The PMIP3 trace gases could also be set at 1850AD values to make these runs most consistent with the CMIP5 model runs.

John Hughes, Met Office Hadley Centre, 2009/11/24 14:19

Hi, CMIP5 CO2 concentrations for pre-industrial are 286 ppmv for 1860 and 285 ppmv for 1850 rather than 280.

pmip3/design/pi/index.1234213686.txt.gz · Last modified: 2009/02/09 21:08 by pasb