This is an old revision of the document!
Go to ⇒ [ 6ka ] - [ 21ka ] - [ LM ]
The Preindustrial control should be the same as the one used for CMIP5 experiments. It is thus the same reference as the one for 20th century simulations and future climate projections (External Link).
PMIP3 | Alternative solution | |
---|---|---|
Orbital parameters | ecc=, obl= °, peri-180°= ° | |
date of the Vernal equinox | March 21 at Noon | |
Trace Gazes | CO2 = ppm, CH4 = ppb, N2O = ppb, CFC = 0, O3 = same as PI | |
Aerosols | Same as PI | |
Solar constant | 1365W/m2 | As in PI |
Vegetation | Interactive | See specific note below |
Ice sheet | Present day | |
Topography and coastline | Present day |
Vegetation
Depending on the complexity of the model used the vegetation will be either
- computed by the model
- prescribed to PI (some ESM may only compute vegetation phenology and carbon cycle).
Land use Land use should be included in the PI vegetation map. In that case, take care that the land use map you use in the PI simulation is consistent with what is done for land use evolution either on the 20th century or the last Millenium.
For Earth System Model with interactive carbone cycle The simlations are force by the CO2 concentrations. Please use the same protocal as in CMIP5 to store the carbone fluxes and the variables needed for PCMIP (see list here External Link)
Insolation Note that insolation should follows PMIP requirements. Please check it carefuly using the following tables (External Link)
Discussion
Since PMIP won't be able to regulate the insolation that people use in the 20C3M runs and the standard controls, and some people will be varying insolation in the LM runs, more guidance is required here. Maybe, we should specify 1850AD conditions?
Then what is the value you recommend in that case / the 1365W/m2 required in PMIP, which is already different from the 1367 a lot of group have in practive in their code? For the orbital parameters I can look at it. But I am not sure we will be able to do something. The real pb is what will be the PI for the Millenium simulations ? It should be year 850, but then how do we connect this with the preindustrial (1860 usually run for CMIP?). Also PMIP gaz etc… was rather 1750 than 1860. I see similar pb with the landuse map.
For the PI for groups only running PMIP3 experiments, we should define both an orbital year and the associated orbital parameters. It would be useful to query the CMIP5 modeling groups to determine what orbital definition will be used in their controls and 20C3M runs. The PMIP3 trace gases could also be set at 1850AD values to make these runs most consistent with the CMIP5 model runs.
Hi, CMIP5 CO2 concentrations for pre-industrial are 286 ppmv for 1860 and 285 ppmv for 1850 rather than 280.