pmip3:wg:degla:bc:core
This is an old revision of the document!
Table of Contents
Last Deglaciation Core Experiment Design
Go back to the main working group page.
Please note this page is a work in progress and not ready for discussion yet.
Proposal
Following wide consultation over the past year, the following is our first-draft proposal for the last deglaciation core simulation. Please use the 'Discussion' section below to comment on the proposal and make suggestions for ammendments.
21-9 ka
All core simulations must span this time-period. Use:
- A spun-up LGM climate simulation to initialise the simulation.
This should have been set up as per the Last Glacial Maximum (LGM) working group requirements and recommendations. - Orbital parameters as per Berger & Loutre (1991).
- Greenhouse gases from Lüthi et al. (2008) and Loulergue et al. (2008) on the timescale of Veres et al. (2013). 1)
- Choice of either ICE6G_C and or Lev Tarasov's global reconstruction of ice sheet evolution.
Whichever is chosen for the LGM should be kept for the whole simulation.
26-21 ka
For those who wish to begin their simulation from before the PMIP LGM, use:
- Orbit as per Berger & Loutre (1991) for this time period.
- Boundary conditions as per the PMIP LGM Working Group.
[ PMIP3 Wiki Home ] - [ Help! ] - [ Wiki syntax ]
1)
The high resolution Marcott et al. (2014) record could be used for an alternative simulation to the core, but not for the core.
2)
Global meltwater fluxes that are consistent with the ice sheet reconstructions will be provided for alternative simulations to the core, but must not be used for the core.
pmip3/wg/degla/bc/core.1423854339.txt.gz · Last modified: 2015/02/13 19:05 by ruza
General discussion on core experiment design